What Is The Difference Between a Drill and a Screw Gun?

In the world of tools, we often find people who believe that a drill is the same tool as a screwdriver. This is not true, however. Both instruments are quite different and have their own jobs. Their differences have been listed below.

What Are The Differences Between a Drill and a Screw Gun?

The Difference is In the Uses

Drills are primarily used for boring holes or driving fasteners. Some drills can also function as a hammer.

Screw guns are used for driving screws into surfaces. They are used to install drywall and other similar materials that need to be installed using screws. Drywall screw guns are fitted with a feature that automatically feeds the drill with screws.

The Difference is In the Look

Drills are fitted with either a drill or a driver. The drill or river is secured with a chuck.

Screw guns are fitted with drivers too. However, instead of having a chuck, screw guns have a nose.

The Difference is In the Revolutions per minute (RPM)

Drills do not need to spin as fast as screw guns. They spin at an average speed of 3000 RPM.

Screw guns spin much faster than drills. They can spin at a speed of up to 6000 RPM.

The Difference is In the Possible Adaptations

Drills can be adapted to work as screw guns. This can be done by obtaining a dimpling bit and fitting it in your screw gun. However, this type of drill-turned-screw-gun can only go so far because the motor doesn’t make as many resolutions as is needed in a screw gun.

Drill or Screw Gun?

Drills and screw guns are two different tools with different functions. While they may look similar each one would likely be useless when the job calls for the work of the other. If you want to bore a hole, you should go for a drill. However, if you are looking to drive a screw, the screw gun is obviously your best bet.

Rather than attempting to fashion a screw gun out of a drill, you should get a screw gun. The best drywall screw guns make driving screws a piece of cake.